Hardwood Floor Refinishing in Medical Lake — Restore, Don't Replace

Serving Medical Lake, west Spokane County & surrounding rural communities  ·  We call back within 1 hour

Scratched, Dull, and Stained — But Not Beyond Saving

Medical Lake homes tend to be older and rural — farmhouses, 1950s and 60s builds, and modest residences that have had hardwood floors for decades without professional attention. The western Spokane County exposure means more dramatic temperature swings and dry winters. These floors often have character that modern lumber can't replicate — the right refinishing approach brings that back rather than replacing it.

The free estimate answers the key question: can your floors be saved, and what will it actually cost?

What Waiting Is Doing to Your Floors

• Scratches go deeper over time. Once the finish layer is broken, bare wood absorbs grit, moisture, and oils from foot traffic. The damage that stops at the surface today doesn't stay there.
• Water damage is cumulative. Repeated moisture events penetrate further into the wood each season. There's a point where refinishing stops being possible.
• Pre-sale window is short. Refinishing requires cure time before furniture goes back. If you're planning to list, this needs to happen before the rush.
• Replacement costs 3–4x more. Refinishing at $3.50–$7/sqft vs. new hardwood installation at $6–$12/sqft or more. When the wood underneath is solid, refinishing is almost always the right call.

How We Refinish Floors

1. Free in-home estimate. We assess the wood — species, thickness, condition, depth of damage — and give you a written quote. Full refinish, screen-and-recoat, or selective board replacement depending on what we find.

2. Stain samples on your actual floor. You pick the color in your own lighting — not from a card. We apply test swatches and you approve before we commit.

3. Dustless sanding. Our HEPA-filtered containment system captures dust at the source. No fine particles circulating through your forced-air ductwork for months after the job.

4. Stain, seal, and finish coats. Two to three coats of commercial-grade polyurethane with buffing between each. Water-based options cure faster; oil-based adds warmth and depth.

5. Cure and handoff. Light foot traffic in 24 hours (water-based) or 48 hours (oil-based). Written care instructions for Spokane's seasonal climate included.

What Our Customers Say

"Older home outside Medical Lake, original floors that had buckled slightly from a past water event. They dried properly, assessed the boards, and refinished everything that didn't need replacement. The result was better than we hoped."

"Had water damage in the entryway from a burst pipe last winter. They documented everything, worked with our insurance adjuster, and matched the replacement boards so well you can't tell. Honest assessment throughout."

What Does Refinishing Cost?

Service	Price Range
Full refinish (sand + stain + seal)	$3.50–$7/sq ft
Screen and recoat (no sanding)	$1.50–$2.50/sq ft
Board replacement (if needed)	$10–$20/sq ft
Stair refinishing	$40–$80/stair

A typical living room (~300 sq ft) runs $1,050–$2,100 for full refinishing. A full home with ~1,200 sq ft typically runs $4,200–$8,400. Quotes are written and itemized — no surprises at the end.

Quick Answers Before You Call